Hello all!
I am looking for a level trim for an X-control. Just to clarify what I want:
I have an engineer who sets the proper level in a particular zone. Then I want the "regular" staff to be able to trim the level in the zone for example +/-3dB. I have looked for a solution but have come to the conclusion that I need a script, am I correct?
Thanks!
regards
Fredrik Setterberg
Soliflex Svenska AB
http://www.soliflex.se

Hello Fredrix,
Nope....
Take a look at this topic in the Knowledge Center;
http://peaveyoxford.com/kc/index.htm#12600
And now look at the attached.
Fergy
(So it looked like it was attached...Now it actually is attached)
Post's attachments
Range Limiting Explanation.npa
167.16 kb, 940 downloads since 2013-10-01

Hi Fergy and thanks for your quick answer. What I am after though is a way to, whatever the position of the fader, the X-control user shall be able to only adjust it +/-3dB for example.
So if the fader is on 5dB, the range shall be between 2 and 8 dB, if the fader is on 10dB, the range shall be 7-13 and so on.